Brivo Onair Release Notes 11.18

8/17/2017

This release includes support for the new ACS300 control panel, as well as adding a new authentication type under application management. Additionally, this release provides several performance improvements and bug fixes.

Improvements

  • Brivo Onair is now capable of accepting ACS300 CP numbers, allowing the new panels to be added to new and existing Brivo Onair accounts. When registering an ACS300 panel, there are additional steps to follow:
    • The initial New Control Panel page remains the same:

  • When the new ACS300 Control Panel is saved, there is a new RS485 section on the View Control Panel page:

  • To edit the RS485 settings, click on the Edit Control Panel button:

  • The ACS300 panel has one OSDP definable port (Port 1):
    • Operation Mode –the port is automatically set to OSDP reader and cannot be changed.
    • Baud Rate – This is the speed at which the information is transferred over the line.
    • Error Detection Method – Allows you to select either Checksum or Cyclic Redundancy Check (CRC) as the method you use for error detection.
    • Peripheral Device Address – Since RS485 is a bus and several devices can coexist on the same bus, there needs to be a way that different devices on the bus can be sent specific messages. Addressing solves this problem.
  • Added a new application authentication type of Invitation under the Application Management tab in Account Settings.

Bug Fixes

  • Fixed an issue where editing holidays incorrectly affected the date fields defaults.
  • Fixed an issue where an error message appeared if a holiday was created without schedules.
  • Fixed an issue where the create door page incorrectly allowed the administrator to create a door already assigned to an Allegion gateway.
×
×
×